-
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 16 of the Death Valley regional ground-water flow system (DVRFS), an... -
Net infiltration of the Death Valley regional ground-water flow system, Nevad...
Recharge in the Death Valley regional ground-water flow system (DVRFS) was estimated from net infiltration simulated by Hevesi and others (2003) using a deterministic mass-... -
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 16 of the Death Valley regional ground-water flow system (DVRFS), an... -
Locations, values, and uncertainties of hydraulic-head observations for the t...
This digital geospatial data set contains the locations, values, and uncertainties of hydraulic-head observations used in the calibration of the transient model of the Death... -
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 1 of the Death Valley regional ground-water flow system (DVRFS), an... -
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 1 of the Death Valley regional ground-water flow system (DVRFS), an... -
Material-property zones used in the transient ground-water flow model of the ...
Zones in this data set represent spatially contiguous areas that influence ground-water flow in the Death Valley regional ground-water flow system (DVRFS), an approximately... -
MODFLOW-2000 and MODPATH model data sets used in scenarios of groundwater flo...
An existing three-dimensional model (MODFLOW-2000) by Fine, Petkewich, and Campbell (2017) (https://doi.org/10.3133/sir20175128) was used to evaluate 7 water-management... -
Simulated constant-head boundary for the transient ground-water flow model, D...
This digital data set represents the constant head-boundary used to simulate ground-water inflow or outflow at the lateral boundary of the Death Valley regional ground-water... -
Model grid and infiltration values for the transient ground-water flow model,...
This digital data set defines the model grid and infiltration values simulated in the transient ground-water flow model of the Death Valley regional ground-water flow system... -
Surface altitudes of hydrogeologic units used in the hydrogeologic framework ...
A digital three-dimensional (3D) hydrogeologic framework model (HFM) represents the geometry and extent of hydrogeologic units (HGUs) and major structures in the Death Valley... -
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 1 of the Death Valley regional ground-water flow system (DVRFS), an... -
Simulated constant-head boundary for the transient ground-water flow model, D...
This digital data set represents the constant head-boundary used to simulate ground-water inflow or outflow at the lateral boundary of the Death Valley regional ground-water... -
MODFLOW-2000 and MODPATH used to evaluate groundwater flow and selected groun...
A previously published groundwater flow model (https://pubs.usgs.gov/sir/2005/5089/) was revised with refined grid spacing and updated hydrogeolgic framework and hydrologic... -
Simulated potentiometric surface contours at end of simulation (1998) in mode...
These contours represent the simulated potentiometric surface at the end of simulation (1998) in model layer 16 of the Death Valley regional ground-water flow system (DVRFS), an... -
MODFLOW-2000 and MODPATH4 used to simulate groundwater flow and contaminant t...
The U. S. Geological Survey, in cooperation with the U.S. Environmental Protection Agency, developed a numerical ground-water-flow model, using MODFLOW-2000, to simulate ground-... -
Initial hydraulic heads for the transient ground-water flow model, Death Vall...
This digital data set defines the hydraulic-head values in 16 model layers used to initiate the transient simulation of the Death Valley regional ground-water flow system... -
Horizontal flow barriers for the transient ground-water flow model, Death Val...
This digital dataset defines the surface traces of regional features simulated as horizontal flow barriers in the Death Valley regional ground-water flow system (DVRFS)... -
Discharge areas for the transient ground-water flow model, Death Valley regio...
This digital data set represents discharge areas in the Death Valley regional ground-water flow system (DVRFS) transient model. Natural ground-water discharge occurs by way of... -
Lateral boundary of the transient ground-water flow model, Death Valley regio...
This digital data set defines the lateral boundary and model domain of the area simulated by the transient ground-water flow model of the Death Valley regional ground-water flow...