Traditional approaches for active flow separation control using dielectric barrier discharge (DBD) plasma actuators are limited to relatively low-speed flows and atmospheric...

Lightweight, high-temperature radiators are needed for future, high-efficiency power conversion systems for Nuclear Electric Propulsion (NEP). Creare has developed flexible...

The innovation described in this proposal is a concept for an instrumented penetrator that can be impacted deep into the surface of Europa and record and transmit data to an...

Traditional design methods for aircraft turbine engine control systems have relied on the use of linearized models and linear control theory. While these controllers can provide...

Hybrid-Electric distributed propulsion (HEDP) is becoming widely accepted and new tools will be required for future development. This Phase I SBIR proposal creates a...

Observation Chambers for Dynamic Microscopic Flow Visualization (DYNASCOPE), Phase II

Multi-Frequency Airborne Radar System for Aircraft Icing Avoidance, Phase II

This Phase I SBIR effort initiates development of a high-sensitivity low-noise all-silicon CMOS-MEMS accelerometer for quasi-steady measurements of accelerations at sub 1...

Under this and several other programs, CTD has developed TEMBOREG deployable solid-surface reflectors (TEMBOREG Reflectors) to provide future NASA and Air Force missions and...

Maxion Technologies, Inc. (Maxion) proposes to develop and field test a Carbon Monoxide (CO)-sensor prototype for post fire cleanup and CO detection. The sensor will have the...

By providing size resolved compositional information, the Aerosol Mass Spectrometer (AMS) has greatly advanced understanding of aircraft particulate matter (PM) emissions. AMS...

Lightweight, high-temperature radiators are needed for future, high-efficiency power conversion systems for Nuclear Electric Propulsion (NEP). Creare has developed flexible...

Plasma Controls, LLC will develop hollow cathode electron sources based on a novel inorganic electron emitting material. Current state of the art cathodes include barium oxide...

Transoner Power Transfer for TWT Power Systems, Phase I

MEMS Packaging for Deep Space Environments Using Nano-structured Polymers, Phase II

The objective of the Phase-I research is to architect, model and simulate a multi-cluster Network on a Chip (NoC) reconfigurable Radio in SystemC RTL, with throughput up to...

Bone Ultrasonic Scanner (BUSS) for Bone Health Assessment, Phase I

Ultrasonic guided wave nondestructive evaluation (NDE) techniques are being used to detect flaws and damage in fracture critical structures such as composites. In order to...

Higher Aspect Ratio Optimal Wing enables a 1.5-2X increase in the aspect ratio of a lightweight wing with safe structures and flight controls.

This Small Business Innovative Research project by Advanced Cooling Technologies, Inc. (ACT) will develop an advanced high temperature heat pipe solar receiver that can be used...