This report describes the FORCE2 flow program input, output, and the graphical post-processor. The manual describes the steps for creating the model, executing the programs and processing the results into graphical form. The FORCE2 post-processor was developed as an interactive program written in FORTRAN-77. It uses the Graphical Kernel System (GKS) graphics standard recently adopted by International Organization for Standardization, ISO, and American National Standards Institute, ANSI, and, therefore, can be used with many terminals. The post-processor vas written with Calcomp subroutine calls and is compatible with Tektkonix terminals and Calcomp and Nicolet pen plotters. B&W has been developing the FORCE2 code as a general-purpose tool for flow analysis of B&W equipment. The version of FORCE2 described in this manual was developed under the sponsorship of ASEA-Babcock as part of their participation in the joint R&D venture, Erosion of FBC Heat Transfer Tubes, and is applicable to the analyses of bubbling fluid beds. This manual is the principal documentation for program usage and is segmented into several sections to facilitate usage. In Section 2.0 the program is described, including assumptions, capabilities, limitations and uses, program status and location, related programs and program hardware and software requirements. Section 3.0 is a quick user`s reference guide for preparing input, executing FORCE2, and using the post-processor. Section 4.0 is a detailed description of the FORCE2 input. In Section 5.0, FORCE2 output is summarized. Section 6.0 contains a sample application, and Section 7.0 is a detailed reference guide.